MultiView Mascot Support

MultiView Mascot Troubleshooting

1. “Cannot update user license using system semaphores”.
   MultiView Mascot makes use of system semaphores so these should be enabled before trying to run the product. You should tune your system to provide this functionality. This may be described in the Operating System Specific Implementations above.
2. Problems when using wide, deep, graphics, local printer and program status line modes.
   In cases where there is more than one possible sequence to terminate one of the above modes, MultiView Mascot will only identify the termination sequence specified by the relevant termcap mnemonic (W1,D1, TGE and DP). As it is not possible to map these mnemonics problems may occur if applications use the alternative termination sequence(s).
3. Marked text missing after Print Window.
   Marked text is no longer present following a “Print Window” operation. The clipboard buffer is common for the Cut & Paste and the Print Window operations. Therefore, the marked text area is lost when a Print Window operation is actioned.
4. Backtab on SCO console.
   The backtab on the certain SCO consoles move's the selection bar down two menu options instead of the usual one. This is due to the console driver outputting the backtab sequence twice.